510 Disposable Electronic Cigarette

1.       Remove the 510 cartomizer’s rubber cover

A 510 cartomizer is a one piece cartridge and atomizer contained in a single unit, storing approximately 1 ml e-liquid.

setup 510 disposable cartomizer

2. Screwing the 510 mini e-cigarette battery

Screw and connect the 510 mini e-cigarette battery to the 510 disposable cartomizer, this places the unit in stand-by mode.

Screwing the 510 mini e-cigarette battery

3. Push the manual button located on the battery part of the unit

Depress the 510 battery manual button holding down for no longer than 5 seconds to avoid overheating. The battery will start the protection circuitry, the LED light flashes 4 times and the shuts down the power, you will need to wait for 3 seconds works again.

510 manual button

d. Charge the 510 mini e cigarette battery

You need to charge the 510 battery when the battery LED flashes 8 times and the circuit stops producing vapor. To charge the battery, screw it into the USB or the AC charger, the battery LED will flash 3 times and the charger indicator light will turn red from the green. When fully charged the indicator light will turn green.

Charge 510 battery

2. Refilling the 510 blank cartomizer

An new empty 510 cartomizer holds about 1 ml e-liquid, but best not fill it up to more than 0.9ml, if you are filling an used empty cartomizer we recommend that you only half fill it, but you can experiment with what works best for you.

 a. Remove the 510 cartomizer’s rubber cover

A 510 cartomizer is one piece cartridge and atomizer contained in a single unit, to refill you will need to remove the rubber cover first.

how to fill the 510 cartomizer

b. Take out the 510 cartomizer’s cover

The base of the cartomizer has a white plastic cover that pops out if you pull it with your nails.

refill 510 cartomizer(cartridge)

c. Take out the 510 cartomizer’s rubber washer

Underneath the cartomizer’s cover, you will find a rubber washer, take that out also.

refill the 510 old cartomizer

d. Fill the e-cigarette liquid to the 510 cartomizer

You can use a syringe to fill the cartomizer or you can pour directly from the bottle, place the syringe to the side the small hole and not directly into the center.

fill e-liquid to the 510 cartomizer

e. Reassemble the cartomizer

Remember to put the rubber back in place, and reassemble in the same way you took it apart. It’s ready to go.

facebooktwittergoogle_plusredditpinterestlinkedinmailfacebooktwittergoogle_plusredditpinterestlinkedinmailby feather